![]() ![]() If you are unsure if your cable is a RS232-Ccable, contact your plotter distributor.USB ConnectionIf you are connectingyour cutter via a USB connection you must install the USB driverthat came with your cutter first. ![]() Select your vinyl cutter/plotter model from the 'Device'drop down boxand select your port.If you are using a Serial (Com) port click on the “Settings”button and set the following settings:-Bits per second: 9600Data bits: 8Parity: NoneStop bits: 1Flow Control: HardwarePlease check your plotter's manual and/orthe Com settings on the plotter's control panel and ensure that theymatch the settings in SignTools.Serial Plotter CablePlease ensurethat your Serial (Com) cable is a RS 232-C cable.SignTools will not communicate with your plotterwith a different cable. Jinka JK721 Vinyl Cutter Setup instructionsSignTools SettingsAfterinstalling CorelDRAW the next step is to install SignTools.Follow the instructions on 4 and 5 of the SignTools 4 User Guide.Once you have installed SignTools, open Corel Draw and click on theApplication Launcher (see picture below) and choose SignTools4.Next click on the 'Cut' button and then the 'Setup'button.
0 Comments
Leave a Reply. |